About amehla

amehla · 11-08-2020

Hi Nick, Looks to be bit strange behavior. Assuming that you have configured clustering configuratio...

amehla · 04-11-2020

Hi Fabrizio, Cisco endpoint can dial using SIP/H323 protocols. Google meet uses a 3rd party GW Pexip...

amehla · 08-13-2019

Lee, Is this behavior is since the installation of this SX unit ? have you tried over a different br...

amehla · 05-07-2014

Hi Tim,ok , at first i was not able to understood this issue properly.so when a call is made from EX...

amehla · 05-07-2014

Hi Tim, In case you are already on a call, then current call will be put on hold when trying to plac...

amehla · 04-29-2014

Hi, Cisco ISDN link only supports Cisco TelePresenceEX, MX, SX, and C Series endpoints.it will not p...

amehla · 04-25-2014

Hi Richard, As of now SX10 only supports TRC 6 remote control with it.it can support touch panel in ...

amehla · 04-23-2014

Hi, you would not need release key for upgrading above TC 6.3 version.adding release key tab on GUI ...

amehla · 04-21-2014

Hi, Could attach a picture of same ?

amehla · 04-20-2014

Hi Clark, Automatic Pairing is supported in software version IL1.1 version along with endpoint versi...

amehla · 04-18-2014

Yes, H265 is introduced with SX80.SX80 is High-end/mid-range codec aimed at the integrator market.

amehla · 04-18-2014

Well C40 and SX20 are two different video conferencing solutions from Cisco, one is integrator (c40)...

amehla · 04-15-2014

Hi software upgrade should not remove IP address information from codec. it does not affect or chang...

amehla · 04-15-2014

Hi Pinkesh, not sure about it but from TC 5 version, Cisco OpenSSL version was from 1.0.1 which also...

amehla · 04-15-2014

this is fixed in TC 7.1.1 version. this is also mentioned in release notes. Regards, Amit

Date Registered	‎06-27-2011 01:00 AM
Date Last Visited	‎02-17-2021 12:04 AM
Total Messages Posted	266
Total Helpful Votes Received	156

Re: Issue with VCS cluster breaking after reboot