Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Please, I need your support and help to be able to view and play the RTSP stream out from the Cisco 6000P Camera direct using VLC.so, if you can send me the RTSP URL, which can be played on VLC? ThanksOmar Mahmoud
Hi,I have a Tanbderg content server V.4, enter the idle mode suddenly, and so this server couldn't be accessed from Network, widows server went down,VGA output disconnected, and the server must be restarted.please, advice how to solve this issue?Than...
Hi All,I have Case: .... please see the diagram in the image below1- ASA Firewall version 8.2.2- Access Switches, and no core switch(s).3- 2 ISPs with different Real IPs Ranges.what i want to do:1- Make the ASA Firewall as a Core Switch "create vlans...
Dear All, Please, advise me how to solve the following issue that I am Facing with 6000MXP Profile Unit, and Also C60 Unit with ASA 7.0.The problem as following:1- H.323 Protocol inspected.2- H.323 Port and Data Ports as following:For 6000MXP:H323 No...
Hi Michael,this issue happens every time i booted the serevr.i didn't upgrade the server since i installed it.this server have recorded only two small V.C session.i found that, this issue almost happens when the server tried to logon the windows, but...
Hi Cristian,Thanks For your Co-Operation..I already did this, and the problem comes when a second source sent (when H239 runs).what can I do on ASA to accept this behavior of H239 with H323.please, help me how to solve this issue.ThanksOmar
Hi Harish, I did what you say, but the problem now, I cannot be reached from the outside "could be called and hear tone only, and then the call will disconnect".what i have to do?, please advice me...ThanksOmar Mahmoud
Thanks for you Co-Operation,but i have a switch, when i plugged the power cord, for a moment (system and alert leds blink orange, but setup led blinks green), and then (system led only blinks green and others off).all ports not working (no indicat...
Dear Cristian,thanks for helping me, i need to know how to integrate adobe connect and Tandberg units, if you have any doc discus this, advice me how to do.Thanks
