Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,I have two out door Cisco C1310 bridges.I'm having issues with data rates speed mismatch. one Bridges is running 36 Mbps and other is running 24 Mbps. Speed configuration is the same in all bridges.please help.
Hi ,We have WS-6509-E and I have noticed this it loaded wrong image. below is results of show version:Cisco Internetwork Operating System SoftwareIOS (tm) s72033_rp Software (s72033_rp-JK9O3SV-M), Version 12.2(17d)SXB11, RELEASE SOFTWARE (fc1)Technic...
Hi ,I have vlan 5 with ip address 192.168.5.1 and standby(hrsp) ip address of 192.168.5.254. All users use 192.168.5.254 as default gateway.I see lot of arp for 192.168.5.1 not 192.168.5.254 when using sniffing tool, is this normal?
Hi,I'm getting the bellow error: 3w5d: %SW_MATM-4-MACFLAP_NOTIF: Host 001a.a18f.bd68 in vlan 2 is flapping between port Fa0/44 and port Fa0/48We have branches connected together with redundancy using motorolla bridges and we have enabled portfast o...
show bootvar:BOOT variable = s72033-ipservicesk9-mz.122-33.SXJ2.bin,1CONFIG_FILE variable does not existBOOTLDR variable does not existConfiguration register is 0x2102Standby is not present.Standby not ready to show bootvarThe image is presence on di...
Hi Sanjay,Thanks. I think I found what was the problem, the boot system command is incorrect:boot system flash s72033-ipservicesk9-mz.122-33.SXJ2.bin, it suppose to be boot system flash disk0:s72033-ipservicesk9-mz.122-33.SXJ2.bin.Will change it and...
