Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWhile trying to change the TACACS server I enteredno aaa-new model before removing aaa authorization exec default group tacacs+ local I saved the config so now I can not enter aaa-new model because the router output is Authorization failed My q...
Hello I have the following issue, CRC errors increasing at the ATM interface level but not AAL5 CRC errors at the pvc level, how come? Hardware is PID: HWIC-2SHDSL #sh int ATM0/0/0.2ATM0/0/0.2 is up, line protocol is up Hardware is DSLSAR, address ...
Hi guys A cisco 1905 is experiencing output drops when I ping with tos0. If I ping with any other class, ip prec 3, 4 or 5 there are no packet drops. For ip prec 5 I have a LLQ configured, for IP 4 just CBWFQ as well as for ipp 3 and 0For IPP3 and 0 ...
HelloIm having problems to ping through interface atm 0/0/0 which is releated to a card HWIC-2SHDSL . The router I haveis a 1941. I dont know what to do.Any clue?sh verCisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M2, RELEA...
Hello I need someone to figure out this quiz. I dont see much logic in the answer. I think some information is missing as to the routers that participated initially in the electionThanks
Hello Neno The problem is that when I reenter aaa new-model for the new TACACS configuration the commandaaa authorization exec default group tacacs+ local of the previous configuration becomes activeand the router wont let me enter any configuration ...
the bandwidth set is 1984 Kbit/seg which is the CIR, shaping is of no use, isnt it? h controllers serial 0/0/0Interface Serial0/0/0Hardware is SCCDTE V.35Clock Freq detected Rx clk/Tx clk 1902055/1902057 (+-10%)
hido you think there may exist a problem with the cabling between the card RJ-11 port and the provider wall box?Or as the controller is up that is not a problem.
