Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have to configure a Cisco SIP phone 3905 in CME ver 8.6. I haven't found a way to do this.I tought about doing it with Fast Track (voice register global-type), but it is supported on CME 10 and above.I was thinking about registering ...
Good afternoon everyone,My client asked me if it is possible to set a warning tone to let users know that the call is taking too long. I know the call duration can be set up, is this related to that?Thanks for the help in advance.Bruno
Hello everyone,I have a problem with an IOS firewall. The thing is that I'm using an FTP client to collect data from the wan (it's on passive mode). The session gets established, through port 21 (wich is on my access-list). I cannot get the transfer ...
Hello Everyone,I am having a bad time configuring a E1. Eveything seems to be fine and up, but i cannot get to make a phone call. My telco says everything is fine on their side, but I get this results on the E1 controller:R_POTOSI#show controllers e1...
Good morning everyone,I have configured an ICCS (non-gatekeeper) trunk between a cucm 8.5 and a cucm 9.1. The trunks works, calls flow in both directions.The problems occurs when I call from the CUCM 8.5 cluster. After I've dialed, the DN appears on ...
Hola Efrain,
Estoy comenzando a configurar FAC en un CME y me sirvió mucho tu post.
El link de los audios está caido, existe alguna manera de que puedas subirlos otra vez?
Te agradezco de antemano,
Saludos,
Bruno
Hello Manish,I believe the UC520 does not support CME 9.0, I downloaded the latest available IOS from cisco and got version 8.6. Is there any other way?
Hello Chris. This is not a SIP trunk, it's a ICCS trunk. I made a lab and it only worked when both servers were 9.1. I got the same results from the TAC engineer.Bruno
