Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to extract the ARP table from an (FMC-managed) FTD 6.1 device, yet I couldn't figure out how to do it. My customer has been doing this at location .1.3.6.1.2.1.4.22.1.2 with his McAfee Sidewinder firewalls I'm about to replace, but FTD doe...
Can anybody point me to the documentation or tell me how to change NTP and timezone settings in the DCNM OVA version running on Linux? I couldn't find anything in the official Cisco documentation and in the DCNM web and LAN client.
Thanks
Toni
I've recently installed FireAMP with TETRA on Windows 7 and 10 and have deinstalled/deactivated any onther security product, including the built-in Windows Defender (which will, annoyingly, automatically turn itself back on after some time).
Shouldn'...
A customer of mine is using ASA CX together with CDA to extract the user-to-IP address mappings. The interaction between CX and CDA is configured and works properly, yet the policies will sometimes not work as intended. We then figured out that CDA w...
My customer has been using a working switchport config that included the same VLAN no. for voice & access. This is supported and documented, e.g. here: http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/vlan/configurat...
Hi MarvinI can't get ASDM to run with the OpenJRE variant, and it seems there's no step-by-step/best practice documentation out there that shows us engineers how to do it.Do you know any source that helps in getting this setup running?Regards, Toni
On a FP4100 with FTD, active/standby, stateful failover is supported. As always, both appliances need to have the same hardware specifications. Licensing doesn't need to match. Check the HA configuration guide:
http://www.cisco.com/c/en/us/td/docs/se...
Hey Jamm1n2780
There's no general answer as every customer has different preferences, requirements and a a different installed base. I'd propose at the license refresh cycle of your traditional A/V at the latest, it's time to reconsider if you still ...
Hi all
Does anybody know of recommendations for FTD deployments regarding inspects? Since good ol' ASA code still runs the lower layers of FTD, have the inspects gone, or are they applied in the background with default settings? I can't find anything...
