Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I was re-reviewing the deployments guides today for the 9971 & 7925 WiFi phones when I noticed that Cisco reccomends changing the EDCA Parameter from WMM to Voice Optimized. It is my understanding and the hitting apply re-affirms that belief that ...
I wanted to run this by the forums members to see if anyone else has experienced this, I have seen a hand-ful of Cisco 1252 access point that have issues with the RJ-45 jack where the cable doesn't seem to sit wierd in the jack and any vibration caus...
I am running ACS 5.2 (more detail below) eval demo version for a proof of concept and noticed an oddity.. It appears that if you create a Endstation Filter and click the CLI/DNIS tab, click Create and then click DNIS and enter your info ex: *coolssid...
I am running ACS 5.2 (more detail below) eval demo version for a proof of concept and noticed an oddity.. It appears that if you create a Endstation Filter and click the CLI/DNIS tab, click Create and then click DNIS and enter your info ex: *coolssid...
I have revised this post.The inital EAP issue was that the client was rejecting the server certificate and it turned out to be a mis-spelling in the certificate on the ACS appliance, but now that this has been resolved I am getting the error that the...
Basically the problem here is there are number of measurements and values that people refer to that are all treated different.
So for example
SNR = Signal to Noise Ratio should always be represented as a positive value number and is based on a scale ...
Just to clarify in regards to the Power Levels a TX Power of 1 is the highest transmit power as George has indicated below this message so 5 would be a lower setting.
The power levels available 1 thru 8 (or 1 thru 5, or variations) are dependent on t...
Bruno,
the Min/Max Transmit Power is a setting that can be configured on the controller to limit or define the transmit power range. From the GUI on the WLC goto the Wireless Tab, then from the left hand menu expand the 802.11a/n/ac (or 802.11b/g/n),...
A couple of things are the floors scaled to proper dimensions and all matching as having the same dimensions? Are you 100% sure all of the access points are presently at the same transmit power level and that RRM hasn't turned some of them down? When...
If you reference this document you will notice that although Australia is -Z for stand-alone access points, it is -N for 802.11abgnac Controller based access points, and -A for 802.11gn Controller based access points.http://www.cisco.com/c/en/us/prod...
