About Kayle Miller

Kayle Miller · 10-20-2010

So I was re-reviewing the deployments guides today for the 9971 & 7925 WiFi phones when I noticed that Cisco reccomends changing the EDCA Parameter from WMM to Voice Optimized. It is my understanding and the hitting apply re-affirms that belief that ...

Kayle Miller · 10-15-2010

I wanted to run this by the forums members to see if anyone else has experienced this, I have seen a hand-ful of Cisco 1252 access point that have issues with the RJ-45 jack where the cable doesn't seem to sit wierd in the jack and any vibration caus...

Kayle Miller · 10-07-2010

I am running ACS 5.2 (more detail below) eval demo version for a proof of concept and noticed an oddity.. It appears that if you create a Endstation Filter and click the CLI/DNIS tab, click Create and then click DNIS and enter your info ex: *coolssid...

Kayle Miller · 10-07-2010

I am running ACS 5.2 (more detail below) eval demo version for a proof of concept and noticed an oddity.. It appears that if you create a Endstation Filter and click the CLI/DNIS tab, click Create and then click DNIS and enter your info ex: *coolssid...

Kayle Miller · 09-30-2010

I have revised this post.The inital EAP issue was that the client was rejecting the server certificate and it turned out to be a mis-spelling in the certificate on the ACS appliance, but now that this has been resolved I am getting the error that the...

Kayle Miller · 04-04-2017

Basically the problem here is there are number of measurements and values that people refer to that are all treated different. So for example SNR = Signal to Noise Ratio should always be represented as a positive value number and is based on a scale ...

Kayle Miller · 05-10-2016

Just to clarify in regards to the Power Levels a TX Power of 1 is the highest transmit power as George has indicated below this message so 5 would be a lower setting. The power levels available 1 thru 8 (or 1 thru 5, or variations) are dependent on t...

Kayle Miller · 05-06-2016

Bruno, the Min/Max Transmit Power is a setting that can be configured on the controller to limit or define the transmit power range. From the GUI on the WLC goto the Wireless Tab, then from the left hand menu expand the 802.11a/n/ac (or 802.11b/g/n),...

Kayle Miller · 08-18-2015

A couple of things are the floors scaled to proper dimensions and all matching as having the same dimensions? Are you 100% sure all of the access points are presently at the same transmit power level and that RRM hasn't turned some of them down? When...

Kayle Miller · 08-18-2015

If you reference this document you will notice that although Australia is -Z for stand-alone access points, it is -N for 802.11abgnac Controller based access points, and -A for 802.11gn Controller based access points.http://www.cisco.com/c/en/us/prod...

Member Since	‎01-24-2007 06:10 AM
Date Last Visited	‎08-19-2022 12:03 AM
Posts	336
Total Helpful Votes Received	480

User Statistics

User Activity

802.11n and EDCA -versus- 9971/7925 deployment guides

Cisco 1252 AP - issues with RJ-45 jack

ACS 5.2 - Swapping CLI and DNIS values.

ACS 5.2 - Swapping DNIS & CLI under Endstation Filters

ACS 5.2, WLC 7.0.98.0, Certificate Authentication

Basically the problem here is

Just to clarify in regards to

Bruno,

A couple of things are the

If you reference this