Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I have number of autonomus aps all cisco aironet 1601. They all advertise same ssid and on different channels. All of them relay dhcp request to the asa firewall. issue is when they roam from one ap to another, they loose connectivity . they...
Hi , Here is a brief overview of my infrastructure and want to get your opinion on it and then have some questions as below . I have 2 backbone L3 switches which all of the other L2 access switches do connect to ( around . Some of the access switc...
Hi All, I am planning to have a radius server installed in my environment. does windows server provide this service? re clients , what software are out there which are free ? thanks
Hi All, I have all my switches configured to run on native vlan 500 and management on vlan 10 with the cisco access point , if I make 500 native or another word trunk untagged vlan then I can't access the router using the BVI interface which is me...
re question 2 , do i need to set it up as filter? I have setup portfast on those links between Serverfarm and backbone (L2 single link) but when I am running show spanning-tree interface .. it shows the status as p2p which it should be p2p edge . aga...
thanks very much .is this by either going to Network --> Network interface --> radio 802.11n 2g.hz and then disable world mode or type no world mode under interface configuration mode? I have done both but still insidder thinks my AP is advertising ...
