Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About dojoy
Stats
Member since
03-09-2012
28
Posts
20
Helpful
4
Solutions
08-20-2013
03:23 AM
Use a normal BRI B2B cable. 4 Cables are used. Side A: 3456 Side B: 5634 Rest are answered here:https://supportforums.cisco.com/message/4003038#4003038
... View more
08-20-2013
03:16 AM
Using the WIC-1B-S/T-V3 Interface alone you wont be able to simulate the back to back. Reason: WIC-1B-S/T-V3 does not emulate as network. e.g. : isdn layer1-emulate network Command wont work. You will have to use an NT/TE Interface to simulate a ISP Side. This interface can support voice calls. Not data calls. Below is the minimum commands required for the ISDN link to come up. NT/TE Interface: interface BRI0/1/0 no ip address isdn switch-type basic-net3 isdn protocol-emulate network isdn layer1-emulate network isdn skipsend-idverify end S/T Interface: interface BRI0/2/0 no ip address isdn switch-type basic-net3 end Hope this helps. -- Regards
... View more
Created by
dojoy
in IP Telephony and Phones
in IP Telephony and Phones
08-19-2013
05:53 AM
08-19-2013
05:53 AM
thanks for coming back.. Please mark the post as solved..
... View more
08-19-2013
05:21 AM
you are moving in the right direction.. Here is the requested info: https://supportforums.cisco.com/thread/2151969
... View more
Created by
dojoy
in IP Telephony and Phones
in IP Telephony and Phones
08-19-2013
05:06 AM
08-19-2013
05:06 AM
Try to deleted the back up device and readding it..
... View more
Created by
dojoy
in IP Telephony and Phones
in IP Telephony and Phones
07-26-2013
04:43 AM
07-26-2013
04:43 AM
From what i know.. You will be able to change the cadence of the ring by setting "Offnet" on Gateway.. But not entirly differnt tone...
... View more
Created by
dojoy
in IP Telephony and Phones
in IP Telephony and Phones
07-26-2013
04:29 AM
07-26-2013
04:29 AM
I do not think thats possible unless you have root access to the CUCM. Reason: here is an ouput from CUCM DB; copy paste the below on a notepad your will understand much better.. admin:run sql select * from enduser where userid = "test" pkid assocpc firstname middlename lastname userid manager department telephonenumber tkuserlocale mailid status facsimiletelephonenumber mobile pager homephone title building site fkdirectorypluginconfig uniqueidentifier nickname deletedtimestamp passwordreverse fkmatrix_presence tkuserprofile fkcallingsearchspace_restrict allowcticontrolflag enablemobilevoice maxdeskpickupwaittime enablemobility remotedestinationlimit ocsprimaryuseraddress enableemcc fkucserviceprofile directoryuri islocaluser fkfeaturegrouptemplate ==================================== ======= ========= ========== ======== ====== ======= ========== =============== ============ ====== ====== ======================== ====== ===== ========= ===== ======== ==== ======================= ================ ======== ================ =============== ==================================== ============= ============================= =================== ================= ===================== ============== ====================== ===================== ========== ================== ============ =========== ====================== 5f7d238c-17cf-345f-fdab-f6b96532242e test test NULL 1 NULL NULL ad243d17-98b4-4118-8feb-5ff2e1b781ac 1 NULL t f 10000 f 4 f NULL t NULL admin: Here we do not find a column which has the field PIN. So inconclution.. you cannot change something that does not exists.. Unless someone can correct me..
... View more
07-26-2013
04:07 AM
Not sure if the issue is resolved or not.. 1. Generally in this scenario you can try downloading the config file of the phone specifically from the TFTP server and check if the firmware mentioned is what we want. 2. Check if the old firmware can be upgraded to the desied one. 3. Check console and sniffers from phone.
... View more
05-17-2013
06:40 AM
If your objective is to monitor people making international and nation calls, why cant you use Extension mobility service and use CDR report to pull out the information.
... View more
Created by
dojoy
in IP Telephony and Phones
in IP Telephony and Phones
05-17-2013
06:37 AM
05-17-2013
06:37 AM
As a "level 1" check you can use the dialled number analyser. Serviceiability page-> dialled number analyser -> Analysier -> Analyse. this will let you know if your CSS and PAT is set right for a specifc number and will also let you know were the call is going to as per the current route plan.
... View more
Created by
dojoy
in IP Telephony and Phones
in IP Telephony and Phones
05-17-2013
06:30 AM
05-17-2013
06:30 AM
The Intergration should work as its listed in the link below for 9.x http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/9_0_1/ccmsys/CUCM_BK_CD2F83FA_00_system-guide_chapter_010011.html#CUCM_TK_C4E65231_00 Its just that its not Cisco tested.
... View more
05-17-2013
06:17 AM
When you create an LDAP Link on the CUCM you would find resync option. "Perform a Re-sync Every" By default it would be around 7 Days. You can try changing that to 1 hour. Let us know if it worked out.
... View more
05-17-2013
05:49 AM
Pretty sure that restart of the TFTP service should get the job done.
... View more
Created by
dojoy
in Networking Documents
in Networking Documents
10-24-2012
06:07 PM
10-24-2012
06:07 PM
he could just unplugg all the servers... that ways he will sure get out.. getting fired is better than "freezing to death"..
... View more
08-20-2013
Use a normal BRI B2B cable. 4 Cables are used. Side A: 3456Side B:
5634Rest are answered
here:https:...
08-20-2013
Using the WIC-1B-S/T-V3 Interface alone you wont be able to simulate the
back to back.Reason: WIC-1B...
Created by
dojoy
in IP Telephony and Phones
08-19-2013
08-19-2013
thanks for coming back..Please mark the post as solved..
08-19-2013
you are moving in the right direction..Here is the requested
info:https://supportforums.cisco.com/th...
Created by
dojoy
in IP Telephony and Phones
08-19-2013
08-19-2013
Try to deleted the back up device and readding it..
Created by
dojoy
in IP Telephony and Phones
07-26-2013
07-26-2013
From what i know..You will be able to change the cadence of the ring by
setting "Offnet" on Gateway....
Created by
dojoy
in IP Telephony and Phones
07-26-2013
07-26-2013
I do not think thats possible unless you have root access to the
CUCM.Reason: here is an ouput from ...
07-26-2013
Not sure if the issue is resolved or not..1. Generally in this scenario
you can try downloading the ...
05-17-2013
If your objective is to monitor people making international and nation
calls, why cant you use Exten...
Created by
dojoy
in IP Telephony and Phones
05-17-2013
05-17-2013
As a "level 1" check you can use the dialled number analyser.
Serviceiability page-> dialled number ...
Created by
dojoy
in IP Telephony and Phones
05-17-2013
05-17-2013
The Intergration should work as its listed in the link below for
9.xhttp://www.cisco.com/en/US/docs/...
05-17-2013
When you create an LDAP Link on the CUCM you would find resync
option."Perform a Re-sync Every"By de...
Created by
dojoy
in Networking Documents
10-24-2012
10-24-2012
he could just unplugg all the servers... that ways he will sure get
out.. getting fired is better th...
Public Statistics
| Date Registered | 03-09-2012 07:03 AM |
| Date Last Visited | 08-18-2017 04:27 AM |
| Total Messages Posted | 28 |
| Total Helpful Votes Received | 20 |
Helpful Votes Given To
Helpful Votes From
