Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to find a good way to one-to-one NAT certain private addresses that are already permitted in a overload from the same pool used by PAT.e.g. access-list 5 permit 10.1.1.0 0.0.0.255!route-map Map-5 match ip address 5!ip nat pool pool-5 1.1...
I understand how to set up DHCP services on a router, but I have a need to have IP's handed out only if a reservation is in place. I would prefer to not have to take the approach of adjusting the pool size every time a new reservation is made. Perhap...
Quick question for everyone: Design Background:I am looking at a potential design implementation utilizing two NM-16ESW-1GIG in one 3845 running (C3845-ADVENTERPRISEK9-M), Version 15.1(4)M4. The reason for selecting these NM cards is based on cost an...
Hope not, the price is right on the nm-16esw-1gig... I would think that since that limitation exists for the vlan.dat file that if it wasn't being utilized there would be no problem with other functions... Hopefully someone wiser than I reads this an...
That would work, but according to the documentation, those are only compatible with the x900 series, I have a 3845...Edit: I need a total of four GigE ports, two for head bandwidth, two for distribution further into the network.Message was edited by:...
