Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am recieving the syslog message below:
%ASA-2-106016: Deny IP spoof from (IP_address) to IP_address on interface interface_name.
A packet arrived at the ASA interface that has a destination IP address of 0.0.0.0 and a destination MAC address of the...
I have configured an ASA 5505 with version 9.2.1 from scratch. I have set up my internal network 10.1.1.0/24 on VLAN 1 and VLAN2 to get IP Add and route via DHCP. I also have set up pat to use the outside address so users can reach the internet. DHCP...
I would like to change my IP Address away from 192.168.0.X/24. If I change the interface will this automaticly update my access lists, nat, ect. for the things tied to this address. Or will I have to go through and reconfigure it all. I will be using...
I have a switch that is on a seperate vlan the connect the san to the VM servers. I would like to be able to manage it through the computer on the main vlan. How should I configure it? As a trunk? But I don't want any traffic flowing through it besid...
I am puzzled. I have followed all of the documentation for setting up a port on our 3750 with span but when I plug the PC with wireshark nothing happens.So far this has been my configuratuion:monitor session 1 source interface Gi1/0/1 - 22 rxmonitor ...
I found out that the ASA had to be upgraded to a newer version and a newer version of the ASDM to work with this version of anyconnect. So I upgraded to 9.1.4 and ASDM 7.1.5. After that I ensured all of the correct anyconnect images where installed a...
My computer is on vlan 1 (192.168.0.X), along with all of my other switches. But there is one switch (2960S) on vlan 31 (172.31.1.X) but all of the port are being used.The only open port on the switch is the FastEthernet port labeled as MNGT BaseT.Co...
