Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Just a quick one, I am little bit confused with the following subnetting question.192.168.8.33/23Need to calculate the following:No of Hosts:No of subnets:Network ID:Subnet mask:Actually they asked me in an interview.Any help will be much appr...
Hi All,I Just setup a cisco 3750 switch with 12.2(55)SE8 image, whenever I connect my laptop or another switch to it takes 20 minutes for the interface to go from orange to green.any help will be much appriciated.Many thanks.
Hi All,I just need to check if the following switches support QoS.Catalyst 3750PID VID: WS-C3750G-24TS-E V07SN: CAT1129RGRUCatalyst 2960PID VID: WS-C2960-24TT-L V02SN: FOC1110Z82LAny help will be much appriciatedMany thanks.
Hi All,I just need to check if my switches are end of sale or life.Catalyst 3750PID VID: WS-C3750G-24TS-E V07SN: CAT1129RGRUCatalyst 2960PID VID: WS-C2960-24TT-L V02SN: FOC1110Z82LAny help will be much appriciatedMany thanks.
Hi All,I just need to check which port my Wireless Access Point(WAP) is connected to on a switch. When I run the following command I get the port channel no. but i need to know which physical port on a switch this WAP is connected to: sh mac address-...
Hi,Thank you ever so much for the info.How would we know that the two networks would be ?192.168.8.0192.168.8.0Many thanks.Sent from Cisco Technical Support iPhone App
Hi,I did not get how did u calculate the two subnets.Could you please explain that,Would be much helpful.Many thanks.Sent from Cisco Technical Support iPhone App
Thanks Joseph,I have got another switch configured with following global commands.spanning-tree mode rapid-pvstspanning-tree portfast defaultspanning-tree portfast bpduguard defaultno spanning-tree optimize bpdu transmissionspanning-tree extend syste...
Hi Joseph,If I apply the following commands globally:spanning-tree portfast bpduguard defaultspanning-tree portfast default and then on the interfaces where gatway is connected:spanning-tree portfast disablespanning-tree bpduguard disable after app...