Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, there are many reason to implement per-vlan STP and choose different Root Switch, one of them is to balance the traficc,
let me do some clarifications,
- all the ports in the root switch are Designated. the root ports only exist in the other swi...
normally you can not do that, because during the 3-way handshake the ASA I is not going to receive the ACK, so after the host send back SYN/ACK the ASA is going to block. but there is an option.
you need to create a servive policy rule, select the i...
you can mix the old version and the new one,so you dont have to take the exam (ROUTE v. 2- 300-101) you need to do the 300-115(SWITCH) and 300-135(T-SHOOT), remember that the exams are valid for 3 years.
please don not forget to rate the post, that ...
in this configuration you need to configure in the host the gateway, that should be that standby ip, that is the virtual IP
Sw A (Active)
!
interface vlan 20
ip address 172.16.20.2 255.255.255.0
standby 20 ip 172.16.20.1
standby 20 priority 1...
