Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've read previous discussions (i.e., "wlc 5508 multiple country codes + mesh ap") on this forum that stated Mesh APs can't be supported on a WLC set-up with more than one country code configured. If you have Outdoor APs which are set-up for local mo...
We recently upgraded our Cisco WLC 5508 from and older code 7.0 to 7.4.121.0 (as well as firmware upgrade). We have quite a few Cisco 1552E APs that aren't operating in a MESH fashion. They each have a wired uplink. They aren't located at any Branch ...
I've been trying to figure out how to delete/remove a dynamic interface in the WLC via GUI and/or CLI. Up till this point, I've only had to add them for our WLAN.According to Cisco documentation I've read, under <Controller> you just click on the blu...
We recently came to realize that we have maxed out our base license for IP addresses in Network Devices. We made the mistake of using "IP Ranges" for all of our Network Devices and AAA Clients, which according to what I've read is the quickest way to...
I'm looking at setting up some outdoor point-to-point connections that range between 7.5 miles and 8.5 miles, and not sure if ExtendAir r5005 can meet the requirements for the range, to extend data between Cisco switches that will be extend LAN servi...
We've never attempted the RADIUS A/V pairs for printers and curious how effective it will be compared to just configuring up printer vlan # on the ports the printers are attached to.
We are in the planning stages of finalizing our 802.1X rollout project, in which the last piece of gear to be added are printers, which will be placed in MAB. Our network printers are made up of a few different vendors. We are running Cisco ACS 5.5 a...
Thanks, that is what I was looking for.We have two main wireless networks, one used for PTP and PTMP and another one that is a mix indoor/outdoor environment providing guest/morale wireless services (different SSID/WLC/Network). Because there are Cis...
I've tried the methods listed above in GUI and in CLI, but have run into another block. After I disabled our WLAN ID and placed it into the "Management Interface", I hit the same issue as before when trying to delete the dynamic interface and when I...
