Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to configure layer 3 port-channel between two Cisco routers. Please share configuration if someone has been implemented the layer 3 port-channel between routers. Thanks
Hello, We have configured GRE tunnel between two location. Tunnel is up and working. As of now Data and Voice are allowed on GRE tunnel. But we are unable to view video of CCTV of location however we are able to ping and trace device over the GRE tun...
We are facing new issue on our controller for Guest SSID. This SSID used for Guest users and it is web base redirected to Aruba CPPM. First time web page redirects to controller virtual IP address and then Aruba CCPM.The scenario is as below- The u...
Dear Team,We are using cisco 3560 switch. Now we are going to implement ipv6 in our network. But we are not disturbing to existing ipv4. my question is 1) Can we confiure the global unicast ipv6 address in ipv6 HSRP and 2) can cisco 3560 switch will ...
Hi Tomasz,Follow the below steps:-1) ensure that the module is detected in switch by show inventory2) Ensure fiber link which is Mumltimode or single mode3) Check red led in module as well as in fiber patch cord. both should be cross.
