Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to block all outgoing multicast streams on my edge switch nexus 3k. The port is connected to a remote location and is a trunk port. I have devices receiving video streams inside my network through this port and I need to keep it working, ...
Hi,Our CUCM is connected to billing systems and used to be working fine, but recently we are experiencing delays in posting CDRs to the billing systems. It seems most calls are getting posted on billing after 2 hours of its occurance. Calls in questi...
Hello,We have Cisco 7606-S with two Sup engine 720 with PFC3B (two WS-SUP720-3B). One of the SUP engine is working fine while the other one is stuck at rommon. Bootflash is empty, but disk0 has the image s72033-advipservicesk9-mz.151-2.SY9 which is t...
Our CUCM-Pub has failed and no good DRS backup. During the following recovery plan based on this guidehttps://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/116946-technote-product-00.htmlAlthough...
Where are you applying this ACL - on nexus switch ? what nexus code running ? Nexus 3064PQ, NXOS: version 7.0(3)I4(6)Please see the output of show version below.on what basis you have identified the traffic rate is only Multicast ?For multiple reason...
I've got no replies so far but I did some updates which I'll add it here. Hopefully, someone with a higher knowledge of this can assist.IGMP snooping is enabled on all the switches and the streaming vlans, and the interface vlan 835 is set to PIM pas...
Hi @Jonathan Schulenberg . Yes off-net transfer. I just did another test now and saw that the CDR is being showed on CAR after the call disconnects but it's taking 2 hours to appear on the billing system. Timezone is 2 hours ahead of UTC time in the ...
