Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a bizarre issue with 2960-X models (WS-C2960X-48FPS-L). After upgrading to any release after 152-4.E8.bin certain devices drop off the network periodically. This can range from every 10 minutes to around 4 times a day. The devices most a...
I'm testing some things out in VIRL and having some issues. I'm not a routing expert and am just getting started with VRFs. My issue is I cannot get the VRF default route to populate no matter what I'm doing. I do plan on putting this into place in p...
Hello, We have our main number that currently goes to a System Call Handler. Our communications department would like an actual person to take these calls rather than a menu. Here are the requirements: Call comes in to x3900User answers the call and ...
We are running Cisco emergency responder 8.5 and have a Cisco WS-C3750-48PS-S Running c3750-ipbasek9-mz.122-55.SE6.bin. Emergency responder is seeing all but one phone plugged into Fa1/0/10. The phone is also not showing up in un-located phones eithe...
When I say not responding yes, no longer replies to ICMP or http requests. The MAC address is also gone from the table. When the device is reachable again, its back in the table. I'll need to break it again and see if I can capture it via wireshark. ...
The most amazing part about this product is the lack of support. Also, I got a survey which I was going to use to complain about how bad its gotten, but the SAML is broken so I can't even complain within the survey.
Unforuntly that did not work for me. Same end results.
switch-1#show ip route vrf Guest
Routing Table: Guest
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter...
Is your ISP router doing NAT/PAT? You need a real router that knows what a VLAN is. Even though 3560 is L3 device it lacks many of the features you need. I'm not even sure where your L3 SVI are according to your drawing.
