Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all. I am trying to open port 1194(openvpn) and forward it to the server I have on the inside. I've followed several different sites that had both ASDM or CLI instructions but to no avail. Would someone be able to suggest what I need to add? I...
I have multiple AWS VPC's that I want to connect to using my ASA5510. Since Amazon IP assignment works differently than in the non-cloud world, can someone provide a sample config for one? Attached is the way I want to connect everything. I just h...
Have an ASA 5510 9.1(2) and ASA 5505 9.1(2)The 5510 is located in the main office and the 5505 is located at a remote facility. I want to create a tunnel that will allow the main office to access the subnets at the remote facility while allowing the...
So I have an ASA 5510 connected to our ISP that's providing us a block of 5 static IP's. One of the interfaces is setup to use one of those IP's. The other interfaces that are configured are all directed to and seen as that static IP. When I try t...
Thank you! I can't recall if that was what I had before since I had tried so many options and was also being pulled in 10 directions at the same time. I ran those entries you provided and I'm in business! Thank you for taking the time!
I think the tunnel is just fine. When I configure a pc at the main office with it's gateway set to use the 5510 and setup a pc at the remote office to use the 5505 as it's gateway, everything communicates across all ports. I'm able to rdp from the ...
From the 5510dalasa> ping tcp 10.166.1.190 3389 source 10.2.100.100 12345Type escape sequence to abort.Sending 5 TCP SYN requests to 10.166.1.190 port 3389from 10.2.100.100 starting port 12345, timeout is 2 seconds:?????Success rate is 0 percent (0/5...
Sorry I did misread your answer. When I run the ping from the 5510 it complains of invalid input.ping 10.166.1.190 3389 10.2.100.100 12345 ^ERROR: % Invalid input detected at '^' marker.When I run it like the following ...
I can ping hosts on the network the asa is on. For example, on the 5505(10.166.1.10), I can ping other hosts in the same subnet. If I try to ping any host on the 10.2.0.0/16 I get the following message.from the 5505ping tcp 10.2.2.10 3389No source ...
