Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,
I configured fingerprinting on Infoblox IPAM. My new outdoor 1562i doesn't work because of the wrong "object ID". Actually, I am using the default one " Vendor Identifier AP.150" which is natively in the Infoblox. You can see more information ...
Dear community,
My ISE crashed after migration to 2.2. In fact, we have 2 nodes (HA with 1st VM as Primary-Admin and Secondary-Monitoring, and 2nd VM as Secondary -Admin and Primary-Monitoring).
As indicated in the upgrade procedure, I began with de...
Hello,
I want to give some right to the hepdesk to allow them to monitor WIFI users. Is that possible to give them only read/monitor right?
I'm using PI 3.1
Thanks
Eric
Hello,
I recently add a new AP 2600 series in my network. I have WLC 8.3.102.0 and Prime 2.2.0.0.158 but I can't view that access point on it.
That AP works well with users connected.
Any idea!
Cheers
Hello,
I don't know why radio was down in some AP and up in others. It's true that when you change manually the status to up, it works better.
APs status goes down because of PoE. When I set power inline to 30000mW, some APs don't work.
I changed to...
