Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I inherited a Cisco 10.5.1 UCCM and Unity 9.0.1 install.When users on their 8945 phones push the envelop button on the phone a secondary pops up is displayed on the phone and ask you to exit or connect. If you push the connect button it will ...
I have a Edge 95 MXP and it call's itself all the time.. the call is a SIP call from 100@it's IP address and is a 64K call. I have not power the unit off because it is up in the ceiling. The unit is also registered as a 3rd party endpoint in Call Ma...
Hi All,I have a Edge 95 MXP that is registered to my CUCM V-10.5.1 as a 3rd party SIP device.I have my TMS server (V-14.4) connecting to my call manager and has imported my other Tandberg/Cisco video enpoints, SX-20's, EX-60's, MX300, but it will no...
Well thanks to Everyone...... It was a Nat call from the outside...... We applied a ACL in the firewall to block the connection!!! Thanks for pointing me in the right direction!!!!!!
