Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,
Brand new installation of Prime 3.1.
All WAN routers are ISR 4321's (26 of them).
Customer has internet pipes at each branch ranging from 10 MB to 50 MB.
Routers have 1 GB interfaces.
Prime is reporting very low interface utilization. This...
Hello, I have a small GNS3 lab that is working with one exception: I cannot ping loopback0 on RRc2 and RRc3 from RRc1. RRc1, RRc2 and RRc3 can all ping loopback0 on SmileyISP and RRc2 and RRc3 can ping each others loopback0interfaces. I am broken bet...
Hello, I have been going over labs, etc., using GNS3 for MPLS, VRF's, etc. Came across something that has mescratching my head. Simple two router setup. Each router directly connected to each other via Gi 1/0. I am providing all configs and relevan...
BD, Ahh... OK. In the original article, the author states that the final piece with the route mapNEXTHOP was supposed to fix the reachability issue. Obviously it doesn't. After reading your last post, I looked more carefully at the output from 'sh ...
BD,I actually found this lab here: https://www.m00nie.com/2010/09/bgp-route-reflectors-gns3-lab/ The solution posted by the author does not work (it even generates an error). I have been trying to 'fix' it with no success. If you look at the site, ...
Eduardo, 1) I am embarrassed by the ping error. I know better than that. I think I was just a bitflustered by the BGP neighbor not coming up. 2) After removing the neighbor statement from the parent it works. Thank you!! Sincerely, Mark
