Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is not so much a post looking for assistance (maybe it will turn in to that, I'm not sure). Rather I thought I'd share what I think is happening now with the VIC 1340 cards so others can avoid some headaches. It looks like Cisco made some chang...
Have you verified that your placement put your adapters in the right order? You set your FC adapters to the highest PCI ID?
Need some more information. Check what ESXi is showing for MAC address for every vmnic and verify they match.
We had this issue recently bringing up a domain that was only rack servers, no chassis. I suspect something went wrong because the domain initially had a chassis and then had it removed.
We we ended up wiping the domain and starting over since it w...
When you query the VIP the response comes back from the active interconnect's management IP. If you look at a state table or packet capture the management interface you'll see the NMS send to the VIP and then the FIs management IP sends the reply, wh...
It will not fail back. You will need to tell the UCS when you log in to switch realms. Hopefully you made a Local authentication realm during setup. If you did, and say it was called Local, you would either select Local from the drop down box for the...
The easy question of connecting the tape library directly to the UCS FI is no since you're already running the FI in end host mode (relying on upstream fibre channel switch). Cannot directly attach the tape drive -- must go through the switch.
As t...
