Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco 4000 series router. All traffic is going over DMVPN tunnels back through our main data center. Would like to route Internet traffic straight out the Internet interface and corporate destined traffic over the tunnels. I lose access to the sit...
I am migrating from a 4500 to a stacked 3850 cluster. I believe the qos dscp trust is automatic by default.. however, how do I enable and set transmit queues?
my old switchport config:
qos trust dscp tx-queue 1 bandwidth percent 60 tx-queue 2 ban...
Existing network, 2 data vlans(A & B), 2 voice vlans...dual circuits (MPLS/Internet).. just upgraded internet circuit from 4m to 50m. Speedtests from vlan A are OK (47down/47up), however any machine on vlan B are incorrect (3down/17up).. ISP router ...
I have about 50 routers and I need to get the age of each. I thought I can get the date from the serial number but unfortunately not. Also attempted router# show rsp chassis command but that is not an available command on any of my routers. any ot...
Should I just have the one default route? I have both configured when i have split tunnel configured.ip route 0.0.0.0 0.0.0.0 (ISP GW IP)remove(?):ip route vrf DMVPN 0.0.0.0 0.0.0.0 x.x.x.x
