Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an ISP-provided MX250 (never doing that again) that needs to have a WAN port configured on the local status page. It appears that the ISP changed the local status page credentials since the default admin/SN do not work. I've opened a ticket w...
We have a Meraki MX250 provided by our ISP. Our contract is almost up, so I purchased another MX250 and plan to swap the old one for this new one.A quick background to our setup, we have two offices, each with an MX250, and we have two MX licenses in...
Our primary internet connection is being discontinued so we are moving over to our backup connection. This backup connection was implemented recently and has been tested for internet, site-to-site VPN links between offices, and VoIP, all working as t...
We've recently moved over to a WebEx Calling hosted solution. Because of some bandwidth issues, I wonder if anyone knows the specific traffic shaping rule we need to turn on. I found the All VoIP & video conferencing setting but there have not been a...
Has anyone hooked up their MS225 stack to a Cisco RPS 2300?I'm looking for directions on how to do this where it will not reboot the switches, if that is possible.Thanks
Thanks so much! I just wanted to make sure we didn't need to have the current password to change it. This is in a remote office, and all I have is remote access to the device, so I cannot do a reset.
It's looking like Method 1 is going to be the way to go. As for the dummy network to get the new MX updated, will us only having two MX licenses make a difference when we add the new MX to this dummy network?I'll do this early one weekend morning, so...
We have an MX250 with low utilization, always under 25%, and just upgraded it from 18.211.2 to 19.1.11. I was hoping this would start showing BLOCKED after this upgrade, but it is still showing ALLOWED.
