Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am just wondering if this is possible, i have a setup as below. R1 Public IP ---internet------Public IP ASA Private IP-----------Private IP R2 This Cisco ASA has a 1 to 1 NAT setup to translate R2 Private IP to a Public IP in both directions.Wou...
Hi, I am running a Cisco 5505 firewall 9.2(4) and have VPN users connecting in using the old Cisco VPN client v5.0.07.0290. When these VPN users login is there a way to include these users VPN login and logout information in the syslog?
BTW the syslo...
Hi all
I hope someone can help, i have a ASA 5505 (9.2(4) firewall that setup as follows.
192.168.246.1/24(inside)---- ASA5505---- 192.168.248.10/23(outside).
My syslog was working OK, with a few messages going to it every now and again, however t...
I, i am having some trouble running a site to site vpn between two 3725 routers running c3725-advsecurityk9-mz124-15T1 which i hope i can get some help with, i am probably missing something here. The VPN ran fine when both VPN routers were connected ...
HiAny chance of doing this without ipsec, to get the throughput that IPIP encapsulation gives with my current router i would need to buy a bigger router if i had to use ipsec.
Just figured it out, the issue was when i screwed up the NAT our cisco router populated its arp table, timeout is standard 6 hrs, so cleared it out and syslog is back to normal again.
