I am planning for a setup which is little bit complicated for me so need your advise :
Scenario is...I have 16 Machines which needs to be on a subnet 192.168.1.x.. Need to run apps which are using broadcast and multicast
I do have 16 dedicated accesspoints as well which needs to communicate with 1 machine per access point
with the trunk port I have a 2900 router connected with in the same subnet leasing DHCP addresses
My plan is:
Create 16 vlans in switch (2960)
Asssign 2 ports for each vlan which will be connected to 1 machine and 1 AP
Trunk connected to Router
So, Machine 1 will only talk to AP 1...Machine 2 to AP2 and so on...
If i connect a wireless client to AP1 or AP2...will it get a DHCP lease from Router which is connected to trunk port of the switch?
On the switch side i know that it is isolated. but with the trunk connected to router..is it going to be broadcast back to other switchports / vlans ?
Thanks in advance for your help
... View more
Dear All I need some support on following scenario Cisco 1900 Router eth0 as PPPOE - Nat and few port forwarding... eth1 as LAN - 192.168.1.1 - Dhcp enabled Above working currently I have additional interface HWIC-2FE card I want to setup as a separate internal network with dhcp nat and port forward. internet will be eth0 PPPOE only Kindly advise
... View more