PPPOE with multiple internal networks

[KAZIM NAIM]

Dear All

I need some support on following scenario

Cisco 1900 Router

eth0 as PPPOE - Nat and few port forwarding...

eth1 as LAN - 192.168.1.1 - Dhcp enabled

Above working currently

I have additional interface HWIC-2FE card

I want to setup as a separate internal network with dhcp nat and

port forward. internet will be eth0 PPPOE only

Kindly advise

[kcnajaf]

Hi Kazim,

This should be fine as far as I know. All you have to do is to enable ip nat inside on the new interface and include the new ip subnet on the NAT ACL.

Hope that helps.

Regards

Najaf

Please rate when applicable or helpful !!!

[KAZIM NAIM]

Thanks Najaf

can you brief a little bit please

Regards