Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI know that to integrate CUCM with SPA IP Phones is necessary to create a SIP profile, so far so good.The problem is how to configure SIP parameters on the SPA phone, someone can help me?best regards
Hi,I have been researching the best solution available in the market for a NetFlow collector.I wonder what solutions are recommend, if the Cisco NAM would be the best choice, I liked the solarwinds solution, these would be your choices, there are bet...
Hi,I’ve got a couple 2060 and a 3750 to L3. Unfortunately I had to take with a wireless solution from HP.Hi have two Vlans for the wireless solution, and I configured my switch port like this:interface fa0/20 description Connect to HP AP switchport t...
Hi, I needed to block traffic between some VLANs by default in the same context of fwsm. Can I remove the permission that allows traffic between VLANs with the same level of security (same-security-traffic permit inter-interface) and put those VLANs ...
Hi,I have several servers with setup teaming, and with this setup I get several messages in syslog server "Received ARP request collision ..."Can I solve this problem in the switch side? thanks
Hi Eugen,The HP support guy told to me that my only option is not to tag the management Vlan. I’m going to your first post, I create a new management Vlan, that is not tagged.Regards and thanks for the help
Hi VijayNo, I dont have the vlan 20 configured as native in the trunk between the 2960 and the 3750. I already question myself and in a previous post if this was not the problem. Tomorrow I'm going to test it, and I will post here the feedback.Thanks...
Hi Eugen,You're right, I could create another vlan and everything would be solved, but I didn´t want to create it for only half a dozen access points. The switch's management VLAN is already full because it is shared by other buildingsThanks
