Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are observing issue of unknown hosts responding in the network with below symptoms!> IP address is pingable from system even if hosts IP doesn't learnt in arp table of SVI in thew network> When trace is initiated for IP, strange dns names are obse...
Hi All,
I have a below doubt on my setup. I am not sure whether setup i have built is as per IDS standards or not but SNORT IDS is not capturing traffic. I want to be sure from switch end i have mapped the needs of IDS. Below is the setup i have buil...
Hi Team,
I am currently working on enterprise setup with ASA between two routed interfaces as below.
Since this is a new setup before presenting the setup diagram to management i have below doubts. Will this work or not, am i missing something?
Setup...
Hi All,
I had a understanding of setting the config register to 0x2102 before IOS upgrade of any router/switches to load the config from NVRAM & IOS from flash during next bootup. This would throw up a prompt under show version as 0x2102 in next relo...
Hi Team,
We have below topology of Nexus 5K & Nexus 2K dual homed to 5k1 & 5K2.
5k1---------------------5k2
! !
!--------fex200------!--------200/1/4----SERVER NIC1
!--------fex 201-----!--------201/1/4-...
Hi, I do recognize the devices in the tracert path, below is the topology i can show, also subnet in the path are known in our network. System----> System SVI on 3850 Stack Switch<-- EIGRP p2p---> ISR Router Local(Location1)<-----GRE/IPSEC Tunnel wi...
This is indeed a design finalized by client. I have joined in the middle of project.
Yes its probably be the Ethernet interfaces between router & asa. I am thinking of using portchannels as there to avoid as port failures which will result in break ...
Hey Reza,
Pleased to hear that, thanks.
So does that mean will it harm if we leave the config register to 0x102 or do we still need that to make 0x2102? If we leave as 0x102 will switch still bootup with existing saved configs?
Regards,
Vishal
