Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am validating the upgrade of a platform using a controller WLC5508 + and AP 2702 both
connected on a switch to release 8.0.140.0.
The upgrade works fine but i have unstability issue with the AP not due to the upgrade.
Two or three times i have...
Hi,I have to establish a tunnel from the local FW to a remote FW in L2LIn case of failure of the remote FW, a tunnel has to be opened with the backup remote FW.I have proposed to use IKEv2But with following config i get the message: %ASA-4-752009: IK...
Hi,I use Annyconnect to permit connection of remote clientsto Inside network.Pool for remote clients 192.168.10.1-100internal network 192.6.0.0Anyconnect works fine to access the internal network but now the customer would like that the remote client...
Hi,I have a case with a customer who has a cluster of two ASA 5510 running 8.4.7.Until now the remote access clients through IPsec tunnel were communicatingwith the internal network of Site A: 192.1.1.0/24.Now the customer would like that the clients...
Hi,Today the customer is using Internet network for establishing a VPN tunnel with a foreign agencybut now that they have added an MPLS network,So they would like to use the MPLS network to reach the foreign agency and in case of f...
Hi,Thanks for the answer.Since the remote solution with 2 ISP's will be in few times replaced by a solution from Security Keepers which has a single public ip address for two routers in hsrp, I think I will stay in IKEv2.Best regards.
