Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have a quick question regarding some twice nat configurations.
I need to know if the following twice nat statement is necessary. (Firewall Spring Cleaning)
Example:
I have a destination in my DMZ that is being natted by yet another Firewall...
I have three locations connected via leased lines. One location feeds the other two to the internet. That location is also where our DMZ's live. In a year or so, we'll be getting an internet connection to one of the other locations.
In the event th...
Hello Everyone!
I believe I have a fun one here.
I have two ASA5550 (failover environment), running 8.4, with both inside and outside interfaces in the same bus. I'm oversubscribed and would like to migrate the inside interface over to the other bus....
Hi all. I'm only in my CCNP studies. I have however spent the last 3 days researching QoS for a 6509e quad 2T sup VSS core. I apparently cannot do MQC QoS on this setup so PFC QoS is what I'm doing. Class Map type lan-queuing match-all VOICE (id 38) ...
I would like to block networks 10.0.0.0/24 through 10.0.239.0/24 from accessing networks 10.0.240/20I've come to the conclusion that the best way of doing this is with 4 separate acl's:ACL 1 - 0.0 - 127.255ACL 2 - 128.0 - 191.255ACL 3 - 192.0 - 223.2...
My two cents: The break could be in any one of those devices or even the transceivers. I don't have much experience with media converters, but I understand the desire/necessity with 12g model switches. Most 12g's after the 3550 eliminated copper port...
I have my WoL server set to 172.16.2.2 in network 172.16.2.0/24 (vlan 2).I have my client station set to 172.16.3.2 in network 172.16.2.0/24 (vlan 3)My WoL server uses port 144 (verified with wireshark). Entered the following commands to set up WoL:...
A show version will display the current IOS flavors on all the switches in the stack.I too am having this issue though. I'm thinking it's because transport output ssh telnet needs to be enabled. But I don't want to let the switches have telnet out ca...