Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure a second overlay interface on my OTV router for the new DR site we're moving to. In my CML lab the new DR overlay(2) works only when I shutdown the current overlay(1). From what I've read it looks like I'm only able to one joi...
I'm new to Nexus gear and I'm having issues with configuring vsan 1 wmn.
When I input the following config I receive an error message:
fcdomain fcid database vsan 1 wwn 10:00:00:90:fa:51:f9:00 fcid 0x980000 dynamic
Error: Invalid FCIDs.
I don't have...
I'm really stuck...
We have a VPN tunnel between two ASA FWs but we're moving one FW off of it's dedicated circuit. We'd like to connect the tunnels with a router in the middle but the tunnels are not coming up. (one FW is MM_WAIT_MSG2 the other MM_...
I have a 3750X-48 stack switch running C3750E-UNIVERSALK9-M), Version 15.0(2)SE.I am unable to configure the SVI with the " ip pim sparse mode" command.When I try to configure the SVI I'm only able to use the "ip pim passive" command. Is my IOS the ...
When I attach the crypto map to the GM's MPLS internet it does not receive the key from the KS but if I apply the crypto map to the loopback interface the keys are received. From a host PC (a switch) at the GM I'm able to ping the KS and other branch...
I'm running Cisco CML and I'm not able to run GETVPN over MPLS either but if I have routers connected to a switch GETVPN works fine. I'm trying to configure this w/o our ISP having to configure anything on their side that's why we're using unicast vs...
Sorry for the late post, but I figured out the issue was on the customer side he did not have the same pre-shared key for the FWs, when he changed it the tunnel came up.
Thanks everyone.
