Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about ACL. I have friend setup with Hub and Spoke setup with IPSEC over GRE and it's working just fine. He has few employee whom need remote access outside of office so until he purchases VPN module and licenses, I need to set him...
In your FXO voice port config, have you tried adding connection plar statement?
voice-port 0/2/X coneection plar opx <extension> timing hookflash-out 50 timing guard-out 1000 caller-id enable
-Deven Gandhi*Please rate all useful post
Since you are using same voice vlan ID in both buildings with two different subnets, how are two building connected and communicate with CUCM? Does building A had it's own WAN router and building B has it's own with two different ISP connection? Or...
Are phones in building A registering to same CM Cluster as in building B? Have you tried deleting ITL file and downloading new one?
-Deven Gandhi*Please rate all useful post
You may want to look at this. This is more for FXO but it may work for your case as well.
https://supportforums.cisco.com/discussion/10805311/cme-external-phone-number-mask
-Deven Gandhi*Please rate all useful post
