If you need FHRP isolation between the sites, this can be achieved by configuring HSRP authentication at one site therefore stopping the HSRP hellos between the sites from being processed and allowing each site to act in Active/Standby state. Due to ...
Unicast NLB is only supported on the N9K when all NLB cluster members must be reachable via the same port-channel/physical interface from the perspective of the N9K so you will need switch/hub in between the servers and N9K, there are no further plan...
Yes this is possible, this can be done by adding the FEX HIF ports into a mode active port-channel. No vPC ID is needed under the port-channel since the FEXs are already dual homed in a vPC.
Take a look at the following link:
http://www.cisco.com/en/...