Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been trying to update the firmware on my EHWIC-4G-LTE-A with no luck. I've been following the instructions found at http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/NIM/software/configuration/guide/4GLTENIM_SW.html#88572, and no m...
I'm working on a home lab setup with my 5506-X, and I've been having an issue configuring split tunneling. Every change I seem to make either gives me internet access, gives me access to the LAN, or takes away both. The current configuration I have...
I'm having an issue with network connectivity with my Sourcefire module. no matter what IP address or default gateway I use in the initial configuration, I can't seem to get it to connect to the network. It's part of a 5506-X. Is there a setting o...
I'm a bit stumped. I have an ASA 5506-X (lab) that suddenly stopped permitting traffic through to my internal subnets. When I run a packet trace, I get this, which stumps me because I've configured a rule to let the traffic through:
RADAR# packet-...
I've recently acquired a 5506-X that I want to use in my home lab to implement Firepower. On the outside interface, it is connected to a cable modem, and it is connected to the 2901 router on the inside interface. I can access the WAN from the LAN,...
That did the trick. I had to solve an issue with DNS traffic not making it across the tunnel after that, but it's fine now. I've been meaning to change the IP address scheme, but then I would have to go in and change all the VLANs, IP addresses on ...
Thankfully this is just in a home lab environment! I actually deleted my other instance that had previously been working (due to an erroneous NAT overload rule initially making everything work then breaking everything on my router) thinking that it ...
Wow.... it turned out not to be anything relating to the firewall. I had overload configured on the router interface that leads to the firewall, and that was hindering the traffic.
