Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWLC 5520,8.3.150.0,AP2802, Dell 7490 (Windows witct corporate certificate) There are more than 100 points in total, the accident appears at different points at different times. Clients periodically can’t connect to the SSID with 802.1x protocol...
Hello everyone. The switch is configured to log in through the ISE. After updating from 16.9 to 16.12 the switch, authentication failed. There are no logs on the ISE when logging in with any account.If you connect with a local account, then enter the...
HelloI'm trying to start using a REST API. I just can’t log in at https:10.78.8.3/api/objects/networkobjectsconstantly logs "%ASA-6-113015: AAA user authentication Rejected : reason = Invalid password : local database : user = asaadmin1" Hardware: ...
Hellofrom time to time clients EAP cannot connect to three or four points out of 100. At the same time, clients WPA2/PSK can connect to the same points. After the reboot of the problem points, the connection is restored. On the rest of the points bot...
performed analysisregarding 802.1 only found this, but I think this is not what I'm looking for 30064General: EAPoL request timeout larger than 400 ms. EAP key requests may benefit for faster recovery, and better behavior on bad RF, by using higher c...
I tried the command "debug client XX.XX.XX" on WLC during the accident. When connected to a network with a PSK, information is displayed. When connected to a network with a 802.1x, there is nothing in the output of the controller. Information does no...
1. I don’t touch the configuration analysis yet, because the accident is temporary and occurs after a reboot point2. during an accident, the command "debug client XX.XX." on the WLC does not output anything, and its output on the point is not analyze...
