Hello!
I have few Cisco 4404 WLC controllers with 1242AG connected and 2 WISM 1. Everywhere is 7.0.252.0 software and country set as Russia Federations (RU). When I update WLC 4404 to 7.0.252.0 software version no one AP's can not register on control...
Hello!
In Russian Main Cancer Research Center we have 6 Cisco 4400 wireless controllers and more then half accespoints - 1000 series (1020). Now we plan to use Cisco Prime 3.0 to manage wired and wireless networks. The problem is - last software th...
Hello!We decide to upgrade to 15.1(2)SY and lost connections to WiSM 1 cardHere the WiSM statusService Vlan : 95, Service IP Subnet : 192.168.95.1/255.255.255.0 WLANSlot Controller Service IP Management IP SW Version Controller Typ...
Helo!I have few controllers and more than 100 ap's. When I connnet ap to the ppoe switch (cat 3560) som ap's detected as ieee pd device and not seen by cdp. This ap's received ip addreses from DHCP and I can ping this device but can not registred thi...
I changed country to Germany and my reg domain is E but nothing changed. Nothing in controller log, no ap registered. But if I change year on controller to 2011 or 2012 - ap's successfully registered and work well. I think it's a mic certificate issu...
Which domain should I select? EE - Estonian, ES -Spain - but we talking about Country domain not about Regulatory right? Regulatory Domain is -AER on controller.
I do not think so. There is no country code Europe, only countries (Spain, Estonia, etc) and second one - i changed year to 2011 - all work well, if I changing it back and reload controller - same situation (AP cannot register)
I changed the system time on the controller, strange situation 1 of 3 test ap - register well but 2 other have a errors in controller log - Cause=Radio interface reset. Status:NA