hello everyone, i have a 2960 compact switch. i wanted to know whether its possible to make this switch transparent. the requirement is that whenever the switch is connected to any lan, it should be able to access the lan without...
hi everybody, we have a print server 2008r2 set up in our network, and the shared path is \\172.20.1.85\printer.the printer ip is 172.20.5.134. all other access rules are working fine except the one highlighted below in red. we want...
hi guys, i have a ghost story to share.. i had configured some access lists in my 3560 switch and after testing everything was working fine. then i had powered off the switch after saving the config. today when i powered it back on, i saw two...
Greetings, i have 12 vlans configured on a 3560 L3 switch and this is trunked to 7 L2 2960 switches. this stack is in a different block. i need to route all these vlans to another core switch from which it will going to firewall and throu...
hi , i have a dhcp server 2008r2 with ip 172.20.1.5 in vlan 3. wanted it give out IPs to vlan 2 and 6. when i apply the access as shown in the config , it does not work. i then tried adding the access list ip access-group 102 out later on ...
yes i can see that i will have some trouble with this. my idea was to connect the 2960 compact switch anywhere with the transparent mode enabled or to another access port of another cisco switch so that the 2960 could access the access vlan of the ...
oh no.. i have not one or two but 12 vlans. but how do i set it to transparent. do i just set it to vtp transparent even though i do not have any vtp domain. and also will it be a trunk port?so basically you are saying that if there is just one vlan...
isn,t there any config inside. what is the model of your switch. did'nt you create any int vlan with any ip?? can you recall.. by any chance does your switch support usb console cable??