Hello, Trying to setup inter region connectivity with csr's and eigrp.I have the tunnels up and can ping internal interfaces and tunnel interfaces from region to region.I haven't had success egressing traffic between the csr to the other region.The s...
Hello, looking to do Region to Region DMVPN within 4 Regions. I prefer not to have the CSR1000v as each subnet gateway. Can I add a 2ndNic/interface add it to the current subnet and use it was a layer 2 local link.orcreate the csr1000v instance in ...
Hello, I am looking for assistance on adding a radius config. for vpn user authentication. Currently, using local db and would like toadd use windows A/D radius and keep the local auth. also for some users. This is for a 5505. THank You
Hello, new to wlc's. Can i simply setup an Security ACL to only allow local wireless clients to LAN subnets.ex: source any dest. 10.0.0.0/8 Thanks in advance
What if using Ospf ? And have 2 point to point links of different bandwidths , would you set the failover using cost ?Sent from Cisco Technical Support iPad App
Pings are also sucessful. /8000It isn't a windows host, it's a video appliance, and the 192.168.1.5:8000 url can be viewed from a web broswer from an internal host on the same subnet and other internal subnets.
Thanks JouniForss, yes we have a few public IP addresses.Phase: 1Type: ACCESS-LISTSubtype: Result: ALLOWConfig:Implicit RuleAdditional Information:MAC Access listPhase: 2Type: UN-NATSubtype: staticResult: ALLOWConfig:object network obj-192.168.1.5 na...