Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Expert:I'm having an issue with L2L vpn, after the configuration is done and I still not able to see the tunnel up from both remote sites. Here is the racap:ArizonaFWL: inside: 10.20.15.0/24 outside: 65.244.227.18/28Denve...
Hello Expert:I'm in the process to configure tunnel l2l and for somehow after I' done the configured the tunnel is not up.Here is the recap:ArizonaFWL: inside: 10.20.15.0/24 outside: 65.244.227.18/28DenverFWL: inside: 10.20.7.0/2...
Hello:Currently we have Cisco 1941 at our corp office that is doing VPN Tunnel. We are looking to replace this device but not sure which model we need to buy to replace this one.Can anyone guide me a right direction. Thx,
Hello:I have ASA 5510 and when I ran packet-tracer from dmz to outside and I noticed that on Phase 5 is show drop with this error " (sp-security-failed) Slowpath security checks failed"Could someone please one tell me if the NAT is sending traffic ou...
Hello:We just received a replacement Cisco 5510 from Cisco contract and I would like to restore the configuration that saved on the thumb drive into a new one.Can someone please help me what is the proper way to complete this task?Thanks again!-HP
Thx for your reply. After I added these two lines and ran show crypto, I still not see the VPN IP addresses on both sides.I already done remap crypto but the issue remains the same. Do you know if I have miss anything else beside ACL lines above.
Thank you for your reply. That is corrected model 1941 ISR. The reason I'm asking because we had this router more than 7 yrs and still running and would like to know what model will work best to replace it.So based on your reply you suggest to use mo...
Indeed that external ip is for a web site and I already configured static NAT on fwl so it should work correct?access-list VoIP extended permit tcp any host 63.64.244.xxx eq httpsstatic (dmz,outside) 63.64.244.xxx 172.16.10.174 netmask 255.255.255.25...
Sorry about that, here you go UtilXVoIPFW# packet-tracer input dmz tcp 172.16.10.174 443 63.64.244.xxx aol detailPhase: 1Type: FLOW-LOOKUPSubtype:Result: ALLOWConfig:Additional Information:Found no matching flow, creating a new flowPhase: 2Type: ROUT...
Hi Alain,Thanks for your reply. Just to confirm once I installed tftp server on local machine and rename the file to cisco5510. After that I just run this command:copy tftp://192.168.1.x/cisco5510 running-config
