Hi,
I'm trying to understand why I can't see secondary path in one of following case scenarios:
a)fa0/0-> delay 100, variance 1:
P 10.10.3.0/24, 1 successors, FD is 158720
via 172.16.3.3 (158720/156160), FastEthernet1/1
via 172.16.1...
Hello,two years ago I wanted to buy ISE-3315 and when we prepared order we were told we have to order following components: - ISE-3315-K9- L-ISE-ADV3Y-100= Today ISE-3315 is EOS and the solution for small business is ISE-3415. The problem is we have ...
Hi,I'm trying to set up different types of VRF-aware VPN and I have a problem with below one:FVRF=VRF1 and IVRF=global, no VRFthere are 2 routers with Loopback1 (global VRF) and gig0/0 (vrf FVRF). When I ping between Loop1's I see ISAKMP and IPsec ...
Hi,I'm trying to configure remote blocking on one router interface. I added: ‘device login profile’, ‘blocking device’ and ‘router blocking device interfaces’. I see the IPS established connection with the router:Extended IP access list IDS_FastEther...
I found the error is a bug. When I changed IOS version the second route is not taken to topology table:
R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#router eigrp 100
R1(config-router)#no variance
...
*Nov 11 23:2...
It's basically scenario B again:
R1#sh ip eigrp topology
EIGRP-IPv4 Topology Table for AS(100)/ID(10.10.1.1)
Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply,
r - reply Status, s - sia Status
...
P 10.10.3.0/24, 1 successors...
ok, I found the reason, with 'all-links' I can see both:
R1#sh ip eigrp topo all-links
...
P 10.10.3.0/24, 1 successors, FD is 156160, serno 140
via 172.16.1.2 (156160/128256), FastEthernet0/0
via 172.16.3.3 (158720/156160), FastEth...
