Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two internet lines and would like to split traffic between the two. One being for web/email the other being for VPN. I assign the relevant IP address to each and can configure one side to work fine. However I cannot get the other side to work....
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
I have a PIX 515E and several interfaces, with two internet connections. I would like to use one connection for internet use and one for VPN. I have added the default route for the internet and added other routes that previously worked on a 1720 rout...
We currently have two 1720VPN routers doing site to site traffic. On one of the routers we wish to split the network traffic through two ISDN lines. We have installed two wic 1enet cards one for each IDSN. We have a default route where all traffic wi...
We are Running a Cisco VPN solution for dial-up users. Using the Cisco client V1.1 they are authenticated using the Cisco ACS server. However when they authenticate they always get the message NO domain Server was available to Validate you Password.H...
I resolved the problem by assigning static IP addresses to the clients. This then made them work. I also get the email problem but not all the time. If you have solved this then please let me knowRegards
