Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are deploying a few 9130AX with eWLC and we noticed an issue.In a network with multiple 9130AX/eWLC, one AP would be elected as Primary WLC, another AP would be elected as Secondary WLC. What we noticed is that, if the CAPWAP is IPv6, the AP Prima...
I am using a Cisco router to connect my internal network with my ISP, but I experienced difficulties configuring multicast for IPTV.
The IPTV require my router to forward both IGMP messages and multicast streams. However, even I enable the multicast ...
Hi all,The network topology is illustrated below:WAN ------ Router ------ L3 Switch ------ Client PIM-SD are configured on both L3 Switch and Router. The Client is going to join a multicast group, for example 239.42.1.1. This join message is received...
My network topology is like this:WAN --- Router(NAT) --- L3 Switch --- IPTV ClientIPTV is based on mutlicast, so IPTV Client needs to join an IGMP multicast group on WAN. This is implemented with IGMP proxy on Router which is described here and here....
There are two VLANs in network:VLAN 30: 192.168.1.0/24VLAN 40: 192.168.2.0/24A IGMP multicast group 224.0.0.251 is used for devices in both VLANs.I try to configure the router to enable the multicast routing, but it seems the router cannot join that ...
@Mark Elsen I'm not sure if the bug you linked is applicable here, but this does remind me one more caveat on configuring the radius authentication in EWC... in Server Group tab, it seems the IPv6 Source Interface must be selected. Otherwise it woul...
Exactly same issue. I have fought against it for years. I am running WLC 4404. iOS devices lost connection periodically, without anything unusual. The Wi-Fi remain connected, but no traffic went through. iOS automatically disconnected from the Wi-Fi ...
Hi Joseph,The static-join will put the Router to announce itself as a host forever. There are nearly 300 multicast streams needs to be forwarded. It is impracticable to join all of them at the same time.Is there anyway to join the multicast streams "...
Hi Reza,I am a bit confused... The WAN of Gi0.34 only serve the network of 10.224.128.0/17. If I place a default route from that interface, wouldn't I get into trouble?Also, for the network 10.224.128.0/17, I believe there is already a route to that ...
