Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have migrated about 40 Ap's from our older WLC 4400 to our new WLC 5508, which has gone rather smooth. But yesterday we were told by a an engineer that we needed to reboot our new 5508. When we did the last 10 AP's still on the 4400 automatically ...
Recently I setup an 1130 AP, it's group broadcasts two SSID's. One for users and one for guests. It's been working solid now for several months. Now users are reports that on the public SSID they are getting dropped and can't reconnect, they time out...
I just recently setup Solar Winds tftp and am using the following commands below to backup my running config to tftp. They do upload to the tftp but every day as a new config is written it's in a numbered seq. (ie-3900-switch backup 1, 3900-switch ba...
Maybe 5 minutes max, I can try to catch them in the WLC. When I see them there they're showing that they're trying to connect and I can see the config version they have associated with them which is the older one from the 4400.
Thanks for the quick response, I'll try to log into them. However they time out on joining and get dropped by the 5508. If I can connect to them, use
#clear lwapp private-config
to clear the config on them?
Looking on the controller that the AP is associated with on the dhcp scope I see that the public wireless is only from 192.168.1.50 - 192.168.1.100. So that needs to be changed, and the lease time is set to 86400. I can change the size of both, you ...
Scott, this is at a satellite campus, and it looks to be trunked. The ap show fine with out errors and all the configurations look right. Contacts on site say that the problem seems to be intermittent. Mostly apple users seem to be effected by this. ...
Where would the switchport config be running at? Here's the thing we're running the ap connected to a netgear smart switch as opposed to a cisco at this location. I'm not familiar with netgear smart switches in the least. I checked the run config on...
