Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Forum,I'm reaching out for an issue I'm having with a Cisco 1100 running IOS 9.17.09.05. The router is connected to 2 WAN ports with a simple failover config. The primary WAN is on G0/0/0 and the backup is on G0/0/1. When ISP1 (ATT) drops, the d...
Hello, I have setup a cisco c1118p and I'm having some difficulty with the load balancing. My setup is with 2 WAN connections. WAN1 is from an ISP (Comcast) and provides a public IP address. WAN2 (AT&T) and is behind a modem. The issue is that the tr...
Hello,I have been trying to create a VPN connection from a Cisco c111 to a remote Sonicwall. The Sonicwall belongs to another company so I'm not fully able to see their side. the VPN is coming from a VLAN with the network of 10.2.1.46/27 to 10.0.0.0/...
Hello,I've been going up and down this issue with trying to create VPN tunnel from our Cisco 1111 to a remote sonicwall that keeps failing phase 2 with an error :ISAKMP-ERROR: (1097):IPSec policy invalidated proposal with error 32ISAKMP-ERROR: (1097)...
Hello,I've recently purchased a Cisco 891 and I have it setup at a local office. I'm having some trouble allowing users access to servers and printers across a security zone.. I setup two different zones (MGMT, In-zone). The in-zone is where the serv...
That solution worked! Thank you for the suggestion!I've posted the updated brief config for anyone who may encounter the same issue:track 10 ip sla 10 reachability!ip local policy route-map IPSLA10!ip nat inside source route-map ISP_1 interface Gigab...
Hi Rob, I cleared the logging and have enabled IPSEC, ISAKMP, and InterfaceCryptographic Subsystem:Crypto ISAKMP debugging is onCrypto IPSEC debugging is onCrypto Interface debugging is on I've tried sending traffic across but it's the same. Syslog l...
