About andy roles

andy roles · 06-24-2015

Hi, I posted earlier but the post became a bit convoluted. I've simplified/clarified my question further here: ip local policy route-map B_INTERNET_OUTroute-map B_INTERNET_OUT permit 10 match ip address B_INTERNET set ip next-hop 10.72.183.129ip ac...

andy roles · 06-24-2015

Hi There, Thanks for reading my post :o) Our company (Company A) is merging with another (Company B) and we currently have a private link between our data centres so we can access each others servers/services.Some users from company B are coming to w...

andy roles · 02-06-2015

Hi there, I haven't had the need to configure routing between different routing domains for for several years and wondered if anyone could advise regarding the following: Our organisation is about to absorb another company 'A' (from parent company 'B...

andy roles · 11-21-2014

Hi there Cisco community.. We are currently in the process of looking for new office space to seat around 500 call centre and back-office staff. The reason for this post is I haven't been in the market for buying new hardware for a number of years no...

andy roles · 10-27-2014

Hi, I removed a hot standby supervisor card and made some changes to the configuration on the primary (remaining) card.I did this because I wanted to quickly go back to a working configuration if anything went wrong during the change I was doing. The...

andy roles · 06-25-2015

Hi Peter, I think the GRE tunnel sounds like a really solution. I used PBR at each hop + default next-hop command and this worked. I will revisit and try your method when I have more time.Big thanks for your input, Andy

andy roles · 06-25-2015

Thanks all, The solution of using the 'set ip default next-hop x.x.x.x' command worked perfectly. interface GigabitEthernet0/0/0ip policy route-map KNSGTN_INTERNET_OUTroute-map KNSGTN_INTERNET_OUT permit 10 match ip address KNSGTN_INTERNET set ip d...

andy roles · 06-24-2015

Thank you Rick!! Having a stressful old time with last minute changes to requirements atm. The help from yourself, Jon and Peter is hugely appreciated :o) Andy

andy roles · 06-24-2015

Thanks Jon!much appreciated.Basically, we just have three sites connected by dual routers in a triangle with a switch LAN enivronment at each site. The 'catch all' route at the bottom of the routing table is distirbuted throughout the whole network ...

andy roles · 06-24-2015

Hi Jon, The policy needs applying across multiple hop. The Path I want the traffic to take is as follows:H:\>tracert 10.72.183.129Tracing route to 10.72.183.129 over a maximum of 30 hops 1 <1 ms <1 ms 1 ms 10.122.37.254 2 <1 ms <1...

Member Since	‎11-26-2013 12:45 PM
Date Last Visited	‎08-18-2017 04:28 AM
Posts	45

User Statistics

User Activity

Policy based routing.. continued

Policy Based Routing and Changing the Default Route to the Internet for only one Subnet

Dynamic or Static: Resilient Connections to a Third Party Network

New campus LAN/WAN harware Recommendations?

6513 - Synchronising a hot standby Sup720??

Hi Peter, I think the GRE

Thanks all, The solution of

Thank you Rick!! Having a

Thanks Jon!much appreciated

Hi Jon, The policy needs