Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One last question but also the most important one, when I change MTU with my script, will that cause inconsistency on the vPCs either glabally or on interfaces..? Will it cause any down time?
Thanks!
To verify enter the following cmd on the N7k.
...
Just remember when you set jumbo frames on 5k via system QOS if you enter the following command you will see the reflected change.
show queueing interface \interface name
Could you issue the following command "show interface trunk”. This command will show your trunk ports and show you clearly the native VLAN ID. The command’s output will go on to tell you about what VLANs are allowed to traverse the various trunks you...
