Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an ASA 5510 with dual ISP. The default route is configured to ISP1, and the inside clients are goes also to ISP1. We have a DMZ interface, there are public servers in it with private IP, the interesting ports are forwarded to them. The public...
Hello,i have a problem with a single port forward with 9.2 ASA (5505). Here is the related config.: access-list outside_access_in extended permit icmp any anyaccess-list outside_access_in extended permit tcp any host 10.168.50.5 eq www logaccess-list...
Hi,we get an NCS Applience with 1.3 sw, and my first thing was to upgrade it to PI 2.0. The problem is that now the ncs service can't start, and i cant open the gui webpage. If i try to start the service, it says "This may take a few minutes..." but ...
Hi!I had a problem, we hav 10+ WLCs in 2 mobility groups, but managed by one NCS. If i make a report about the rouge APs, it contains the APs from the other WLCs also from the other and the same mobility group. How can i make it that the report not i...
But it seems yes :).I moved this back to section 1.:nat (Guest,outside) source dynamic obj_any interface The object is.:object network obj_any subnet 0.0.0.0 0.0.0.0 I think i should specify it more.
I think about the inside VPN NAT rule, the DMZ VPN rule was moved earlier to section 3. One of these rule matched before the port forward.:nat (Guest,outside) source dynamic obj_any interfacenat (inside,outside) source static any any destination stat...
