Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi forum.
I am trying to configure two separate IPSEC tunnels on the same physical interface on my ASAv 9.8 code. Will this be technically on asa ASAV ?
Dynamic IPSEC in one side (reasoning dynamic IP) and Static or Routed IPSEC in the other side...
hi, I want to get TACACS traffic which is coming from ASA1 itself going through the IPSEC tunnel to the ISE. But how do I put the traffic coming from ASA1 itself to the IPSEC tunnel?
Hi Forum.
I cannot get my HP printers to be profiled correctly as HP Laser Jet XX model. I have enabled DHCP, SNMP Trap & Query, Radius profiling services. My HP Printers are profiled as "HP-Device". Is there any way to profile HP printers as the ori...
I am trying to access/export my WSA appliance logs (access logs etc). But for some how I cannot authorize with my administrator login via the FTP link from GUI.The login window appears again after typing username and password in my browser. What shou...
Hi Forum. I am about to upgrade my distributed ISE installation from version 1.4 to version 2.1. In this case I would hear about your experiences with it.
Since the GUI upgrade are not supported from version 1.4 to 2.1. I guess this should be done vi...
Thanks for quick reply. ASA1 Outside interface is external IP address. Will it be possible to NAT to RFC1918 address and put that into the tunnel?
Lets says. If ASA1 wants to communicate with ISE. It should source from: 100.100.100.100 and not from i...
Some more information. I cannot find place to enable the FTP. But I guess it is enabled since I got login prompt. So I will not belive that is the case. Please check out the Message from the FTP client.
Appliance mode:
Model: S160Version: 7.1.4...
